词语吧>英语词典>eccentric angle翻译和用法

eccentric angle

英 [ɪkˈsentrɪk ˈæŋɡl]

美 [ɪkˈsentrɪk ˈæŋɡl]

网络  离心角; 偏心角; 離心角

机械

双语例句

  • The influence of eccentric block inc-luded angle on shock force and shock moment are explained.
    说明了两偏心块的夹角对激振力和激振力矩的影响。
  • Flow velocity of fluid in eccentric spiral rectangular section channels varies in periodical non-linear relation with angle of curve.
    偏心螺旋矩形截面通道中流体速度随转角(弧度)呈非线性周期变化。
  • The modified eccentric circular centrode has been obtained by reducing the polar angle of polar equation of eccentric circular centrode by integral multiple.
    通过使偏心圆齿轮节曲线的极坐标方程的极角按整倍数缩小的方法获得了变形偏心圆齿轮节曲线的极坐标方程。
  • The orbit control technology of two long-distance satellites with similar semi-major axis, eccentric angle and inclination RAAN was analyzed.
    文章对半长轴、偏心率、倾角、升交点赤经相近的两航天器的远距离轨控接近方案进行了理论分析。
  • Experimental research on RC eccentric compression column strengthened with the combination of CFRP and angle steel
    外包钢与碳纤维布复合加固钢筋混凝土偏压柱试验研究
  • The first-order relative position equations are expanded as trigonometric series with eccentric anomaly as the angle variable. Except the terms of order one, the trigonometric series 'amplitudes are geometric series, and corresponding phases are constant both in the radial and in-track directions.
    通过将相对位置方程的径向和横向分量以偏近点角为变量展开为三角级数,发现除了一阶项外,三角级数的幅值为等比数列并且相角为定值。
  • In order to estimate eccentric MR, two parameters named turbulent intensity and regurgitate angle were proposed to modify the effective regurgitate orifice area ( EROA) based on traditional PISA algorithm.
    针对这一现状,从返流角度和湍流强度两个方面,对传统PISA算法的有效返流瓣口面积(EROA)进行修正。
  • THE ECCENTRIC DEGREE CONTROL OF MICRO RADIAL GRATING Development of Circular Grating Angle Measuring Meter
    微型圆光栅刻划偏心量的控制圆光栅测角仪的研制
  • The elliptical gears and the eccentric gear are taken as examples to show the change of engagement angle and the constraints on the engagement angle in design.
    以椭圆(含高阶椭圆)齿轮及偏心圆齿轮为例,给出啮合角变化的规律及啮合角约束条件。
  • Calculation Method of Increment Value of Eccentric Angle in Milling of Ellipse Contour Using Macro-program
    宏程序铣削椭圆轮廓离心角增量值的计算方法